ADEMCO 4140XMPT2 Uživatelský manuál stáhnout pdf (Strana 28)

ACTION DESIRED

=You must define a Stati zone list (z/) for these

applications to work properly.

●Can be used to turn on lights in a specific room or area.

For example you can automatically turn on the basement

/ight on entry.

CHIME

Close relay for 2 seconds during chime. (Chime mode 1

must be turned on at control)

Chime on Specific zones:

gdri~i~qz~~i~;(%j @W,~$&yfO~~,S~@$ ~{g~~itiq~j $,i:::

..,,.,,,..

“Will

activate relay for any zone type plus panics on 5601

whether control is armed or disarmed. (Console panics will

not activate a relay with the configurations above.)

Zones in zone list (x) close relay for 2 seconds on alarms 1

Zones in zone list (x) close relay for 2 seconds on troubles 1

Close relay after any burglary alarm and reset at bell

timeout or when disarmed by any partition.

*Response types 06,08, and 09 wi// not activate re/ay. /f

PULSE relav is desired, enter a 3 in A(actionl.

Zones in zone list (x) pulse a relay after alarms and reset

when disarmed by either parltion.”

Close relay when ARMED-AWAY, reset when

DISARMED. (Any partition)*

Close relay when ARMED-STAY, reset when DISARMED.

(Any ~artition)’

‘If PULSED relay is desired, enter a 3 in A(action).

Bypassing a zone causes relay to close and will reset with 2

a disarm sequence (code+ off.)

CONFIRMATION OF ARMING DING

Close relay for 2 seconds at end of exit delay time after

system is armed

START

28 -

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 67 68

Žádné komentáře

ADEMCO 4140XMPT2 Uživatelský manuál Strana 28