ADEMCO VIA 30+ Průvodce řešením problémů stáhnout pdf (Strana 81)

15–7

Press

✱

73 AC RESTORE REPORT CODE

This is sent when AC power has been restored after an AC power

outage.

Press

✱

74 LOW BAT RESTORE REPORT CODE

This is sent when a system low battery condition is restored to

normal.

Press

✱

75 RF XMTR. LOW BATTERY RESTORE CODE

This is sent when a transmitter that previously sent in a low battery

message has sent a message indicating it no longer has a low

battery condition.

Press

✱

92 NUMBER OF REPORTS IN ARMED PERIOD

This option can be used to limit the number of messages (alarm &

alarm restore reports) sent to the central station in an armed

period. “0” limits reports to a total of 10; “1” allows an unlimited

number of reports.

Press

✱

94 DOWNLOAD PHONE NUMBER

Enter up to 12 digits;

0–9, # + 11 for “

✱

”, # + 12 for “#”, # + 13 for a pause. Do not fill

unused spaces. End field by entering “

✱

”. To clear entries, press

✱

Press

✱

95 RING DETECTION COUNT FOR DOWNLOADING

Refer to the chart below and program this field accordingly.

Voice Answering

Module Machine Downloading Field

✱

95 Programming

Yes No No Set for value other than “0” (1–14). This

will enable the control panel to answer

the phone call. Otherwise, it will not be

possible to access the module.

Yes Yes No Set for a value higher than the number of

rings for which the answering machine is

set. Example: if machine is set for 4

rings, use value 5 or higher. This is

recommended so that the Phone module

can still be accessed if the answering

machine is turned off and does not

answer the phone call.

Yes No Yes Set for value other than “0” (1–14).

Yes Yes Yes “15” to bypass answering machine.

No No No Enter “0”

No Yes No Enter “0”

No No Yes Enter 1–14

No Yes Yes Enter 15. See Imortant Note below.

Important Note: If “15” is entered in field

✱

95 to bypass an answering machine, and a

4285 Phone Module is included in the installation, you should note the following:

When calling in from an off-premises phone (to receive a status report or execute a

command), the user should make the initial call, allow 1 to 3 rings only, and hang up.

Then call in again – the Phone Module will now seize the line, and 2 long tones will

heard, followed by the usual voice prompt for the 2-digit phone access code. If this

procedure is not followed, Phone Module operation will not be possible.

✱

96 INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. No. FOR

DOWNLOADING (No data entry required)

This completes the communication programming.

Exit the programming mode by keying

✱

99.

Refer to

the

TESTING THE SYSTEM

section to check system operation.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 103 104

Komentáře k této Příručce

Žádné komentáře

ADEMCO VIA 30+ Průvodce řešením problémů Strana 81

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO VIA 30+