ADEMCO 4120XM Uživatelská příručka stáhnout pdf (Strana 40)

Programming Steps

1. Enter Programming mode

Programming mode can be entered in one of two ways.

a) Press both the [K] and [#] keys at the same time within 30 seconds after

power is applied to the Control. OR

b) Key the installer code, followed by depression of CODE [8] + O + O keys.

The factory installer code can be changed once in the program mode.

Immediately following entry into the program mode, the following will be

displayed on an Alpha console:

Program Mode

● Fill # View -00

Fixed-word consoles will display: 00

Following the above display, the system is ready to be programmed for the

communication format parameters, or accept data entries. To begin data

entries, press [x] plus the first field number desired.

2. Set Standard Defaults

Once the Programming mode is entered, clear the system’s memory by

pressing ●97, This ensures all program fields are set to their factory set, pre-

programmed values.

If desired, load one of the communication default

programming sets by entering one of the following code sequences:

TABLE OF DEFAULT PROGRAMMING COMMANDS

I PRESS I TO LOAD THIS DEFAULT SET

●97 I

Loads standard default values for the panel

*94 *8O Low Speed communication defaults

*94 *81 Ademco Express communication defaults

*94 *82

Ademco High Speed communication defaults

*94 *83 Contact

ID communication defaults

Refer to the PROGRAMMING COMMUNICATION DEFAULTS section for

further instructions if one of the four communication default programming sets

is used.

3. Program the data fields

Program the appropriate phone numbers and account numbers, as well as

any other programming fields required to customize the system to the needs

of the installation. Refer to the PROGRAMMING FORM at the end of this

manual.

4. Enter Zone Descriptions (Alpha consoles only)

Refer to the PROGRAMMING ZONE DESCRIPTIONS section to enter zone

descriptors and a custom installer’s message.

5. Exit Programming Mode

When all fields have been entered and checked, and zone descriptors have

been assigned, exit programming mode by pressing either *98 or

●99. A

second entry of

●99 is required if the exit is being done from fields 1●OOand

above. To prevent re-access to Programming mode using the Installer’s code,

use

●98. The only way to re-access Programming mode is by depressing both

the [x] and [#] keys at the same time within 30 seconds of power up.

Exiting by using

●99 always allows reentry into Programming mode using the

Installer’s code. Either way of exiting will allow access via downloading.

-40-

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 79 80

Komentáře k této Příručce

Žádné komentáře

ADEMCO 4120XM Uživatelská příručka Strana 40

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO 4120XM