ADEMCO Vista-20HW Uživatelský manuál stáhnout pdf

VISTA-20HWSE

2-PARTITIONED

SECURITY SYSTEM

PROGRAMMING

FORM

Principal changes between the VISTA-20HWSE and

the former VISTA-20HW are indicated by margin lines.

VISTA-20HWSEPRV2 8/97 (See Instructions N7526-2V2)

WWW.DIYALARMFORUM.COM

1 2 3 4 5 6 7 8

VISTA-20HWSE 1
WWW.DIYALARMFORUM.COM 2

Shrnutí obsahu

Strany 1 - VISTA-20HWSE

VISTA-20HWSE2-PARTITIONEDSECURITY SYSTEMPROGRAMMINGFORM®Principal changes between the VISTA-20HWSE andthe former VISTA-20HW are indicated by margin li

Strany 2 - WWW.DIYALARMFORUM.COM

– 2 –Local programming requires the use of a 2-line Alpha keypad connected topartition 1 keypad terminals on the control.NOTE: For UL installations, t

Strany 3

– 3 –*37 AUDIBLE EXIT WARNING [1] [1]Part. 1 †Part. 2 † 0 = no; 1 = yes*38 CONFIRMATION OF ARMING DING [0] [0]Part. 1 †P

Strany 4

– 4 –*49 SPLIT/DUAL REPORTING [0]0 = Disable (Backup report only)TO PRIMARY PHONE No. TO SECONDARY PHONE No.1 = Alarms, Restore, Cancel Others2

Strany 5

– 5 –EXPANSION ZONES: Assign zone numbers (Zn) 10–17 to 4219/4229 Auxiliary Wired Loops A–H, if used.ZONE ZONE ZONE PART'N ALARM RPT CODE INPUTDE

Strany 6

– 6 –OUTPUT AND SYSTEM SETUP (*80–*93)*80 OUTPUT RELAYS AND POWERLINE CARRIER DEVICESProgram only if Relays and/or Powerline Carrier devices are to be

Strany 7

– 7 –OUTPUT RELAYS/POWERLINE CARRIER DEVICES WORKSHEET FOR *80, and *81.Applicable only if Relays and/or Powerline Carrier Devicess are to be used.*80

Strany 8

*81 ZONE LISTS FOR OUTPUT DEVICES – This is an interactive mode. Fill in the required data on the worksheetbelow and follow the procedure in the insta