ADEMCO Vista-20HW Specifikace

9,39LVWD,QWHUDFWLYH3KRQH0RGXOH,QVWDOODWLRQDQG6HWXS*XLGH®N6431-3V1 10/99

4286 VIP Module Installation and Setup Guide2-2Wiring Connections1. Make 12V (+), Ground (–), Data in, and Data out connections from the4286 VIP Modu

Section 2. Mounting and Wiring2-3Do NOT connect speakers in parallel.Do NOT use a single 4-ohm speaker.Damage to the 4286 may result.Special Wiring N

4286 VIP Module Installation and Setup Guide2-4

3-1SECTION 3Programming••••••••••••••••••••••••••••••••••••••••••In This Section♦ Programming the Control for 4286 VIPModule Usage♦ Entering the 4286

4286 VIP Module Installation and Setup Guide3-2Entering the 4286 VIP Module Programming Mode:1. Pick up a premises touch tone phone connected to the

Section 3. Programming3-3• Field 00: Monitored Keypad AddressThis field enables or disables the 4500 thermostat AND speaker output fea-tures and sel

4286 VIP Module Installation and Setup Guide3-42. Enter the same address in this fieldIn a system that uses non-addressable keypads:Set this field to

Section 3. Programming3-5installation where descriptors have already been programmed, check to besure that those descriptors can be annunciated by th

4286 VIP Module Installation and Setup Guide3-6Programming NoteBe sure that all programming changes made to the control are uploaded viaADEMCO’s V–LIN

Section 3. Programming3-7Programming Relay Voice DescriptorsWith some controls, certain lights/appliances can be turned on and off via thetelephone u

4286 VIP Module Installation and Setup Guide3-8RELAY VOICE DESCRIPTORS VOCABULARY & CUSTOM WORD SUBSTITUTES(4286 VIP Module only)Table 3-2The Word

Section 3. Programming3-9When programming or making test calls to emergency numbers, briefly explainto the dispatcher the reason for the call. Perfo

4286 VIP Module Installation and Setup Guide3-10Table 3-3 (cont’d)SPEAKER CONTROLCATEGORIES DESCRIPTIONWARNINGS:1 = Yes, 0 = NoControls all sounds i

4-1SECTION 4Basic Operating Guide••••••••••••••••••••••••••••••••••••••••••In This Section♦ Phone Code♦ Setting the PhoneCode ♦ Phone Access When On-P

4286 VIP Module Installation and Setup Guide4-2If the code is not accepted, there will be no system status report heard. Thecontrol may have been acti

Section 4. Basic Operating Guide4-33. Enter the 4-digit system security code. As a safety feature, there is a 3-try limit in which to enter each co

4286 VIP Module Installation and Setup Guide4-4A list of confirmation sounds and voice announcements that follow successfulcommand entries is provided

Section 4. Basic Operating Guide4-5Remote Access CAN be turned OFF from an off-premises phone, butCANNOT be turned ON.If Remote Phone Access has bee

4286 VIP Module Installation and Setup Guide4-6End User Relay Command Mode WhenUsing the 4286 VIP ModuleFor information on whether operation of the en

Section 4. Basic Operating Guide4-7Using the Phone Panic FeatureOn-premises Touch-tone phones wired as shown in the 4286 “Summary ofConnections” can

iTable of Contents••••••••••••••••••••••••••••••••••••••••••Section 1. GENERAL DESCRIPTION ...

4286 VIP Module Installation and Setup Guide4-8About the Speaker OutputPressing “✴ ✴” on the monitored keypad will trigger a status announcementfrom t

5-1SECTION 5Troubleshooting••••••••••••••••••••••••••••••••••••••••••In This Section♦ Typical System Problems and Solutions•••••••••••••••••••••••••••

4286 VIP Module Installation and Setup Guide5-2Remote Phone Access Keeps Turning OffAutomatically.• Improper keying (or attempted tampering)from an ou

Section 5. Troubleshooting5-3In a 4140XMP Installation, Descrip-tions of Zones Annunciated Are NotCorrect.• In an existing 4140XMP installation, allz

4286 VIP Module Installation and Setup Guide5-46. If there is incorrect programming ofRF zones for the 4281 or 5881 Re-ceiver. If more RF zones have b

A-1SECTION 6Appendices••••••••••••••••••••••••••••••••••••••••••In This Section♦ In the Event of Trouble with Regular Telephone Service♦ Federal Commu

4286 VIP Module Installation and Setup GuideA-2FEDERAL COMMUNICATIONS COMMISSION (FCC) PART 15 STATEMENTThis equipment has been tested to FCC requirem

Section 6. AppendicesA-3TELCO-PROVIDED COIN SERVICE ADVISEMENT:This equipment cannot be used on telephone company-provided coin service. Connection t

4286 VIP Module Installation and Setup GuideA-4YELLOWNO CONNECTIONREDBLACKGREENTO CONTROL PANEL KEYPAD CONNECTIONSKEYEDHEADER1 2345 6 7NOCONNECTION428

ADEMCO LIMITED WARRANTYAlarm Device Manufacturing Company, a Division of Pittway Corporation, and its divisions, subsidi-aries and affiliates ("S

Table of Contents (cont'd)iiSection 5. TROUBLESHOOTING...

165 Eileen Way, Syosset, New York, 11791Copyright © 1999 PITTWAY CORPORATION¬19QlN6431-3V1 10/99

1-1SECTION 1General Description••••••••••••••••••••••••••••••••••••••••••In This Section♦ Application and Description♦ Control Panels Supported ♦ Diff

4286 VIP Module Installation and Setup Guide1-2When connected, the 4286 VIP Module will enable the user to do the follow-ing via any Touch-tone teleph

Section 1. General Description1-3®The 4500 thermostat cannot be used in UL installations.• Synthesized voice prompts to instruct the user on how to i

4286 VIP Module Installation and Setup Guide1-4

2-1SECTION 2Mounting and Wiring••••••••••••••••••••••••••••••••••••••••••In This Section♦ Mounting the 4286 VIP Module♦ Wiring Connections♦ Speaker Co