ADEMCO 4160-12 C-COM Specifikace stáhnout pdf (Strana 9)

This position may te used to conserve pa~r, since only one line

will be printed for each incoting messa&. When in the MANUAL

mode, this position will also wnserve internal message stora~

space since unverified messages wU1 not be stored.

Two exceptions to this position exist:

If m data ton= are heard after the ‘lHandshakeWtone is

sent, a message will be @nerated as an indication o? “no trms -

mission.” This is used to indicate the possibility of an attempt

to jam the incoming phone line.

If a call is handled without a successfd message receipt

(OO kissoff tone is sent), the last message “round” to be

received will be printed, as

an indication of a “bati

transmission.m

This feature may te used to help deterdne the

location of a defective commmicator.

In both of the above cases, a TRANSMISSION ERROR message will

be printed and displayed follming the m=sage (see “SYSt~

Messagen Section ~ E 2).

U (b) Pmition: All incoming transmissions, whet~r valid

or not, will be displayed (and printed).

DISPLAY =XT =SA= Mtcb : This momentary action ~shbutton is

used to cause the next message stored in the memory to be displayed

(and printed) when the receiver is in the MANUAL mode. A new massage

will & displayed for each push of the button until the mamory has

been emptied, at which time the display will clear. In the AUTO mode,

this button fmctiona as the nClear Displayttbutton.

BATTSRY TEST Sfit& (and LED): This mmentary action pushbutton

is used to initiate or cancel a battery test.

The purpose of the battery test is to test the rendition of the bac~p

battery.

During a Mttery test, the No.

585 is operated frm the battery alone

fo? a period of 5 minutes. If during that ‘time, the battery voltage

f~ls balw the lW battery threshold, the test is terminated and

a BAT~RY TEST FA~URE message will b printed and displayed (See

Section IV E 2).

If the battery voltage remains abve the lW kttery threshold (11.2

volts), a BAT~RY TEST PASS message will be displayed and printed

(See Section IV E 2).

To ifitiate a battwy test:

Press and hold the BATTSRY TEST button

until the LED to the left of it k@na to flash (abut 2 seconds).

To cancel a battery teat, once it has be-: Press and hold the

BATTSRY T=T button until the LSD stops flashing (about 2 seconds).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Komentáře k této Příručce

Žádné komentáře

ADEMCO 4160-12 C-COM Specifikace Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO 4160-12 C-COM