1 it whenever all zones are intact (ready for arming) during
the disarmed state.
It 1s
off at other times.
ENTER Key:
When depressed subsequent t0 security code and function
or mode entry, eliminates the 2 second keying, delay that exists
prior to acting on the function or mode request (use of this
key is optional).
FIRE and FIRE Keys and LED (Red):
Simultaneous depression of
both keys causes manual activation of the fire alarm (if fire
is programmed for Zone 4).
The FIRE LED is lit when a fire
alarm has been caused by this means or by a short in the fire
zone and remains as a memory of alarm after timeout.
POLICE and POLICE Keys and LED
(Red): Simultaneous depression
of both keys causes manual activation of a Zone 5 alarm (audible
or silent as a function of zone programming). The POLICE LED
is lit when a Zone 5 Police alarm has been caused by this means
or by a fault in Zone 5 AND,Zone 5 has been programmed with
the console display enabled. It remains lit as a memory of
alarm after timeout.
EHERG and EMERG Keys and LED (Red):
Simultaneous depression
of both keys causes manual activation of a Zone 6 audible alarm
(if Zone 6 was programmed as a 24 hour alarm zone). The EMERG
LED is lit when a Zone 6 Emergency Alarm has been caused by
this means or by a fault in Zone 6 AND Zone 6 has been programned
for 24 hour emergency alarms.
It
remains lit as a memory of
alarm after timeout.
AUX
and
AUX Keys
and LED
(Red): ,+lot Used - Future Application.
ZDIE. IE~IFICATION DISPLAY (Red): This one digit display provides
the zone identification for each zone programed as a burglary
zone during the disarmed and armed states, for both current
faults as well as for memory of alarm.
IUNUNJtY Message Display (Red):
This message is displayed subsequent
to intrusion in one of the burglary zones when the system is
armed and remains, along with the Zone
I.D.
Display, as a memory
of alann after the alarm condition is removed.
CHECK Message Display (Red):
This message is displayed subsequent
to a trouble condition being detected in Zone 4, when this zone
is programmed as either a fire zone or a day trouble burglary
Lone,
and remains as a memory of the trouble after the trouble
condition is removed.
PHONE Uesuge
Display (Red):
This message lights steadily while
any phone transmission (except-a silent alarm where the system
is programned for console inhibit) of an alarm,trotile,open/close,
cancel, or restore is in process.
When the central alarm monitoring
service receiver acknowledges the transmission with a kiss off,
the message will flash for 30 seconds.
628-12
689
Komentáře k této Příručce