ADEMCO 4160-12 C-COM Specifikace stáhnout pdf (Strana 17)

Acknowledge Halt PRM Options

30 seconds - standard

. 60 seconds -

slow response central station systems

Message transmission will begin when the acknowledgnent is received. The system

will transmit in the Ademco LOW or HIGH SPEED formats depending upon which

acknowledgnent tone has been received from the central station.

The latter

is not true for SESCOA or Radionics Superfast formats which are specifically

programa& for proper response to their acknowledge and acknowledge-hold receiver

signals.

Transmission Fomat PRO4 Options

Ademco High Speed Chly

. Ademco High or Low Speed (depends on C.S. receiver tone received)

SESCOA

. Radionics "Superfast"

NINE:

Extended reporting from each of the above formats is separately

PROM selectable.

To ensure proper transmission, each message is sent up to four times. As soon

as the central station receiver verifies the message, it sends a "Kissoff"

tone to the system.

This causes the PHONE display on the console to flash

for 30 seconds.

B&sage Verification PRQl aptions

Two successive identical messages - Ademco Fb. 673 and 685 receivers

as well as Adcor, Franklin, Radionics, SESCOA, Silent Knight,

and Vertex receivers.

Single message transmission with check sum verification - Ademco

A. 685 (in High Speed Format only) and Radionics

If the system does not receive the "Kissoff" tone, it will disconnect and dial

again.

It will make as many attempts to obtain kissoff via the primary and

secondary phone numbers as is PROM programmed.

Muco law Speed Reportlng Fom

This message consists of the last 3 digits of the subscriber identifi-

cation nunber and'a single digit alarm code PRO?4 assigned to that

alarm/trouble/status 'report.

If more than one alarm is triggered, the alarms will report in priority

order (i.e. low alarm code first) unless tb subsequent alarms trigger

while one or more alarm messages have already

ned transmission.

Each message must receive

"kissoff" before the next is sent.

Example: If codes 3 and 6 of Subscriber -1890 are to be reported, the

system will respond as follows:

628-17

694

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 58 59

Komentáře k této Příručce

Žádné komentáře

ADEMCO 4160-12 C-COM Specifikace Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO 4160-12 C-COM