ADEMCO 4160-12 C-COM Specifikace stáhnout pdf (Strana 49)

NDTE:

When key arming stations are used, the only type of arming

that can be performed at them is AWAY Mode arming. The

RED LED on this type of station indicates arming of any

type -

AWAY or STAY.

Depart before the exit'delay period ends, via an entry/exit.door.

WME:

Failure to arm is indicated by a single tone at consoles and

keypads and by failure to turn off the OFF LED (at consoles)

and turn on either the AWAY or STAY LED (or the Red LED at key

arming stations).

To Msam Burglary System:

1. When entering the prmlses, enter only via the entry/exit door.

A slowly

pulsing tone will be heard from consoles and keypads during the entry

delay period.

JM&:

If a rapidly pulsing tone is heard, it is an indication of the

memory of an. alarm that took place previously.

The user should

immediately leave the premises and call the police from a safe

location.

already within premises,

go directly to the nearest console, keypad,

or key arming station.

Before the entry delay period (If any) ends, enter the security code and

OFF or turn ara/disam key.

MITE:

While the system is disarmed,

the READY and Zone LEDs will go

on and off as the protected.zones open and close during normal

operation of doors, windows, PIRs, etc....

To Test FI re System :

The fire system should be tested at least every week.

IMRlAWl:

The test described below causes communicator transmission of

a Test Report to the central station.

1. Slide the FIRE TEST/RESET switch on the C-CO!4

the right and hold It

In that position.

The fire alarm will sound and the FIRE LED will light.

While this switch is held to the right, the AC driven power supply is

interrupted, thus checking the ba.ttery by sounding the alarm from battery

alone.

Release the FIRE TEST/RESET switch and reset the system

sliding the

sme sultch to’the left to the RESET pusltlon.

This will silence the

alarm sounding.

Clearing of the FIRE LED indication from the console

and fmn the CCC44 will either require security code entry plus OFF depression

at a console or a keypad or turning of the key in a key arming station.

628-49

726

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 58 59

Komentáře k této Příručce

Žádné komentáře

ADEMCO 4160-12 C-COM Specifikace Strana 49

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO 4160-12 C-COM