ADEMCO Alpha Vista Console Manuál s instrukcemi stáhnout pdf (Strana 22)

PROGRAMMING THE SECURITY CONTROL

Installer options are

stored in non–removable, electrically erasable. non–

volatile EEPROM memory.

These options

must be programmed for the particular

installation to establish its specific alarm and reporting features.

The security control may be programmed from

an optional 5137 or 4137 remote

console,

or can be programmed locally from the 699 Programmer.

Information

regarding the Programmer is

included with the No. 695–30XT Programming

Cartridge.

When programming from the 5137 console,

prompts for each field description (only

field number will. be displayed on the 4137 console) and field number will be

displayed on the 2–line, 32–character LCD display; also, each entry is displayed

as it is keyed in. After programming,

values that have been entered in each

field can be reviewed and, if neccesssary, modified.

The system is factory–programmed to a set of preset values, which can be altered

by the installer to

suit the specific needs of a particular installation or

installation company. The preset values are detailed in the Factory Programming

Table.

Note:

Programming information is stored in non–volatile 3EPROM memory in the

control (removal of power will not result iv the 10SS of the

information). Consequently,

it is possible to program the system at

any time – even at

the installer’s premises prior to the actual

installation.

Simply apply power temporarily ?a ‘:he control and the~

program the unit as desired.

When programming from the console, note the following:

Enter the Programming mode by simultaneously depressil~; The * and # keys

within 30 seconds after pwer is applied to the Control, or subsequently k.y

keying the code 4 + 1 + 4 + O followed by depression of CODE + O + O keys.

Once an installer code is programmed,

use it instead of 4140 to gain access

to the programming mode.

2. Immediately following entry into the program mode, the following will be

displayed on a 5137:

Program Console

* Fill # View – 00

and on a 4137: 00

To program a data field, key * PIUS Address (for example, *01), then make

the required entry. To simply rwiew a data field, key # plus Address.

When a data field has been completely programmed, the console will “beep”

three times and then automatically proceed to, and display, the next data

field address to be programmed.

4. If the number of digits that you enter in the data field is less than the

maximum permitted (for example,

phone number), then the console will

display the last data entered.

To proceed, the next data field address to

be programmed must then be entered (for example, *05).

If an address is improperly entered, the console will display FC . If a

program entry is improperly entered (for example, a larger number than that

which is permitted),

the console display will go blank.

In either case,

simply re–enter the number.

The following is a description of commands necessary for programming:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Komentáře k této Příručce

Žádné komentáře

ADEMCO Alpha Vista Console Manuál s instrukcemi Strana 22

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO Alpha Vista Console