ADEMCO 5130XM Manuál s instrukcemi stáhnout pdf (Strana 58)

SYSTEM OPERATION

.-.

TEMPORARY CODES

Temporary

Security

codes can be assigned and deleted by user 2 (with

(USERS %3 - A22)

Master Code) or user 3 as follows:

User 2: Master Code + CODE key + User # (0322) + Temporary Code

User 3: User 3’s CODE + CODE key + User # (04-21) + Temporary Code

User numbers must be entered as O-digit entries. Single digit user numbers

must, therefore, always be preceded by a ‘0” (example, 03. 04, 05, etc.).

Make sure the end user understands this requirement.

User 2 can assign temporary codes to all users, 3-22. User 3 can assign

temporary codes only to users 4-21. The system will emit a single beep when

each temporary code has been successfully entered.

Note: When a temporary code is inadvertently repeated for different users, or

one user’s code is anothers duress code (see below), the lower .user number

will take priority.

To delete temporary codes, do the following:

Master Code + CODE key + User # + Master Code

Note that user 3 cannot delete the temporary code assigned to user 22.

IMPORTANT!: Unless Ademco Contact ID reporting is used, only user

codes #1

- #15 can uniquely report to the central station using the

communication formats provided. Users #16 - #22 will report as User #15, if

enabled for open/close reporting, for the other repotting formats.

DURESS CODE

The VISTA System duress code is a means of sending a silent alarm to a

central monitoring station if the user is being forced to disarm (or arm) the

system under threat. This feature is only useful if the system is connected to

a central station. When the system’s Auxiliary Voltage Triggers are

connected to another communication’s media (Derived Channel/Long Range

Radio), note that duress is signalled on the same trigger that signals silent

panic (whereas duress has its own unique report when digitally

communicated).

The duress code is simply the usual security code, but with the fourth digit

increased by 1. For example, if the security code is ‘1 2 3 4’, the duress

code is ‘1 2 3 S. When used, the system will disarm (or arm), but will also

send a silent alarm to the central station. There will be no indication at the

console that an alarm was sent.

Note that duress codes are not available for security codes ending in the digit

‘9’.

IMPORTANT!: Users of temporary codes should be instructed to enter

their codes carefully, to avoid the possibility of accidentally entering the

duress code.

Do not assign sequential temporary codes 1 digit apart from each other (8x.

4096, 4097, 4098) as this will cause a Duress to be sent each time (one

users code is another useI’s duress code).

,Y----.

; ‘.

ADEMCO~ VISTA xm SERIES TECHNICAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 158 159

Komentáře k této Příručce

Žádné komentáře

ADEMCO 5130XM Manuál s instrukcemi Strana 58

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO 5130XM