ADEMCO VISTA-20HWse Průvodce řešením problémů stáhnout pdf (Strana 46)

–46–

60 TROUBLE REPORT CODEÊÊ(See box above) 0 | 0

This will be sent if a zone goes into trouble.

61 BYPASS REPORT CODEÊ (See box above) 0 | 0

This will be sent when a zone is manually bypassed.

62 AC LOSS REPORT

See box on previous page. Reports with Partition 1 Subscriber No.

Timing of this report is random with up to a 4-hour delay. If AC restores

before the report goes out, there is no AC restore report.

63 LOW BAT REPORT CODE Ê 0 | 0

This will be sent when a low battery condition exists in the system’s

standby battery. See box. Reports with Partition 1 Subscriber No.

64 TEST REPORT CODE 0 | 0

This is sent periodically to test that the communicator and phone lines

are operational (frequency of report is selected in field *51). See box.

Reports with Partition 1 Subscriber No.

65 OPEN REPORT CODEÊ 0

This is sent upon disarming of the system. See box. 2nd digit = user

number, if expanded or 4+2 reporting is selected.

66 ARM AWAY/STAY REPORT CODE 0 | 0

This option allows for independent programming of AWAY and STAY

reports for each partition. 2nd digit of report is user number if expanded

or 4+2 reporting is selected.

NOTE: OPEN reports are not sent in if the associated closing report is

not enabled.

68 CANCEL REPORT CODE (See box on previous page.) 0 | 0

This is sent upon disarming of the system after an alarm condition was

reported.

RESTORE

REPORT CODES

(*70Ð *76)

*70 ALARM RESTORE REPORT CODE, 1st DIGIT 0

This is sent when the zone that caused an alarm is restored to its non-

faulted condition. 2nd digit is automatically sent as the 2nd digit of the

zone alarm report code programmed in field *56, if expanded or 4+2

reporting is selected.

71 TROUBLE RESTORE REPORT CODE 0 | 0

See box. This is sent when a trouble in a zone is restored.

72 BYPASS RESTORE REPORT CODE 0 | 0

See box. This is sent when a zone that has been bypassed is un-

bypassed.

73 AC RESTORE REPORT CODE 0 | 0

This is sent when AC power has been restored after an AC power

outage. See box. Reports with Partition 1 Subscriber No.

74 LOW BAT RESTORE REPORT CODE 0 | 0

This is sent when a system low battery condition is restored to normal.

See box on previous page. Reports with Partition 1 Subscriber No.

76 TEST RESTORE REPORT CODE 0 | 0

This is sent when the test mode is exited. See box. Reports with

Partition 1 Subscriber No. A restore code entered

here will cause a restore message to be sent when Test mode is exited.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 83 84

Komentáře k této Příručce

Žádné komentáře

ADEMCO VISTA-20HWse Průvodce řešením problémů Strana 46

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO VISTA-20HWse