ADEMCO VISTA-20HWse Průvodce řešením problémů stáhnout pdf (Strana 52)

–52–

If a "SYSTEM OPERATION" is chosen (e.g., End of Exit Time),

that operation will cause the device to activate as selected in

"ACTION.” The different choices for "ZONE TYPE" and

"SYSTEM OPERATION" are listed in “Programming Output

Relays & Powerline Carrier devices” later in this section, and in

the Programming Form.

2 Partition No. (P): The device's "Start" ZONE TYPE/SYSTEM

OPERATION may be limited to an occurrence on Partition 1,

Partition 2, or any partition (A).

STOP (STP):

The "STOP" programming determines when and under what

conditions the device will be de-activated. The following

options are available:

Upon Restore of a Zone List

1. Restore Zone List (ZL): If a "ZONE LIST" is used as the

“Stop” event, the device will de-activate when all the zones in

that list restore from a previous fault, trouble, or alarm

condition. This will occur regardless of what is programmed

to "START" the device; therefore, a "RESTORE ZONE LIST"

would normally only be used when a "ZONE LIST" is used to

start the device.

Upon a Zone Type or System Operation

1. Zone Type/System Operation (ZT): Instead of using a

"RESTORE ZONE LIST", a specific zone (response) type or

system operation action can be selected to de-activate the

device.

If a specific "ZONE TYPE" is chosen, any zone of that

response type that restores from a previous alarm, trouble, or

fault condition will cause the device to de-activate.

If a "SYSTEM OPERATION" is chosen, that operation will

cause the device to de-activate. The different choices for

"ZONE TYPE" and "SYSTEM OPERATION" are listed in

“Programming Relays & Powerline Carrier devices” later in

this section, and in the Programming Form.

2. Partition No. (P): The device's "Stop" Zone Type/System

Operation may be limited to an occurrence on Partition 1,

Partition 2, or any partition.

During normal system operation, any devices may be

manually started by keypad entry of: Code + # + 7 + ÒnÓ or

manually stopped by keypad entry of: Code + # + 8 + Òn,Ó

where “n” = the device number to be controlled.

As a minimum, the ACTION (A) and PARTITION No. (P) fields

must be programmed for this manual action to be operative.

If a relay is energized before a 4-wire smoke detector is reset,

the relay will be stopped by the interruption of Aux.

Power that

resets the smoke detector. If this is not desired, the power to

the relay unit should be supplied from another 12V power

source (e.g., the same source that is powering external

equipment through the relay contacts).

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 83 84

Komentáře k této Příručce

Žádné komentáře

ADEMCO VISTA-20HWse Průvodce řešením problémů Strana 52

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO VISTA-20HWse