ADEMCO VISTA-128B Průvodce nastavením stáhnout pdf (Strana 135)

Section 22 – Data Field Descriptions

22-15

1*73 PRINTER BAUD RATE

[0]

Enter 0 if printer is set for 1200 baud (preferred).

Enter 1 if printer is set for 300 baud.

Note: Must be

if using the alpha numeric pager interface.

1*74 RELAY TIMEOUT XXX MINUTES [000]

Enter the relay timeout, 000-127 in multiples of 2 minutes, desired for #80 Menu Mode

time-driven event relay command numbers "04/09" and Relay Programming in the #93

Menu Mode Programming output command "56" (refer to #93 Menu Mode and

Scheduling sections in this manual).

1*75 RELAY TIMEOUT YYY SECONDS [000]

Enter the relay timeout, 000-127 seconds, desired for #80 Menu Mode time-driven event

relay command numbers "05/10" Relay Programming in the #93 Menu Mode

Programming command "57" (refer to #93 Menu Mode and Scheduling sections in this

manual).

1*76 ACCESS RELAY # # (partition-specific) [00]

The system can be programmed to provide user-activated access control. If enabled, the

assigned relay will pulse for 2 seconds when the user enters his code and presses 0.

Enter the relay number (00-32) for the relay that will be used for access control. Enter

00 if not used in this partition. This function has not been UL Listed for use with the

VISTA-128B control. Must be 00 for UL installations.

*Note: See the Access Control section for enhanced access control capability.

2*00 NUMBER OF PARTITIONS

[1]

Enter the number of partitions (1-8) to be used in the system.

2*01 DAYLIGHT SAVINGS TIME START/END MONTH [04,10]

Enter the months (00-12) in which daylight savings time starts and ends.

Enter 00, 00 if daylight savings time does not apply to the user's region. Standard

setting for U.S. is 04,10.

2*02 DAYLIGHT SAVINGS TIME START/END WEEKEND [1,5]

Enter the start and end weekends for daylight savings time as follows: 1=first;

2=second; 3=third; 4=fourth; 5=last; 6=next to last; 7=third from last. Standard setting

for U.S. is 1,5.

Fields 2*05 – 2*08 must be set to 0 for UL installations.

2*05 AUTO-ARM DELAY (partition-specific) [15]

Enter the time between the end of the arming window and the start of auto arm

warning time in values of 01-14 times 4 minutes.

Enter 00 if no delay is desired.

Enter 15 if auto arming is not desired.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 251 252

Žádné komentáře

ADEMCO VISTA-128B Průvodce nastavením Strana 135