ADEMCO 4140XMPT2 Uživatelský manuál stáhnout pdf (Strana 51)

– 51 –

Programming Steps

1 . Set the consoles to the appropriate addresses.

2 . Set factory defaults by pressing *97.

This will automatically enable console addresses 00-03, so be sure at least

one console is set to one of these addresses.

3 . Program system-wide (global) data fields

Using the programming form as a guide, enter program mode and program

all system wide programming fields, including phone numbers, as well as

any other programming fields required to customize the system to the

needs of the installation. These options affect the entire system,

regardless of partitions. They include control options, downloader and

dialer options, RF options, event logging options, etc. Refer to the

PROGRAMMING DATA FIELDS section for a listing of the program fields

arranged by function.

Note that fields 1*26 & 1*27 (5700 RF device selection),

field 2*00 (number of partitions), field 1*32 (RF expander

type) must be programmed before continuing.

4 . Program partition-specific fields

When the system-wide fields have been programmed, program all

partition-specific programming fields by first pressing *91 to select a

partition 1-8 (while still in data field program mode). Then enter the first

partition-specific field number *09. The next partition-specific field will

automatically be displayed when you are finished entering the value for

field *09. Partition-specific fields can have different values for each

partition. To program the fields for the next partition, press *91, enter the

desired partition number, then enter field *09. Refer to the

PROGRAMMING PARTITION SPECIFIC FIELDS section for instructions.

5 . Use #93 Menu Mode for device programming

Refer to the DEVICE PROGRAMMING section to assign console ID

numbers and default partitions for each console, and to selectively

suppress certain console sounding. Use this mode to assign RF receivers

as well.

6 . Use #93 Menu Mode for zone programming

Refer to the ZONE PROGRAMMING section to program zone response

types, assign right loop zones and wireless zones, and assign zones to

partitions and program dialer reports.

7 . Use #93 Menu Mode for programming alpha descriptors

Refer to the ALPHA PROGRAMMING section to enter zone and partition

descriptors and a custom installer's message.

8 . Use #93 Menu Mode for programming relays

8 . Set Communication Defaults

Refer to the COMMUNICATION PROGRAMMING section for further

instructions if one of the four communication default programming sets is

to be used.

9 . Exit Programming Mode

Exit programming mode by pressing either *98 or *99. A second entry of

*99 is required if the exit is being done from fields 1*00 and above.

To prevent re-access to Programming mode using the Installer's code, use

*98. The only way to re-access Programming mode is by depressing both

the [*] and [#] keys at the same time within 30 seconds of power up.

Exiting by using *99 always allows reentry into Programming mode using

the Installer's code. Either way of exiting will allow access via downloading.

Note that if local programming lockout is set via downloading, programming

mode cannot be entered at the console.

10. Use #80 and Scheduling Menu Mode and #81 Temporary Schedule mode

to program open/close schedules and time driven events.

11. Use #83 User Scheduling Menu Mode to program end user relay or X-10

operation schedules.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 131 132

Komentáře k této Příručce

Žádné komentáře

ADEMCO 4140XMPT2 Uživatelský manuál Strana 51

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO 4140XMPT2