ADEMCO Security System VISTA-15CN Průvodce nastavením stáhnout pdf (Strana 107)

Section 22 - System Operation

22–3

If you armed the system using the [C] (NIGHT-STAY) key, your only option is to use the

[A] (AWAY) key to increase the level of security. (These lettered keys must be pressed

and held down for a minimum of 2 seconds).

• The [A], [B], and [C] keys are disabled for panic operation.

These arming-level changes transmit an Opening report followed by the appropriate

report of the armed state to the Central Station. The security code is always required,

however, when disarming the system.

When an alarm occurs,

keypad

sounding and

external sounding occur, and the zone(s) in alarm are displayed on the keypad. Pressing

any key silences the keypad sounder for 10 seconds. Disarming the system silences both

keypad and external sounders. When the system is disarmed, any zones that were in an

alarm condition during the armed period are displayed. To clear this display, simply

repeat the disarm sequence (enter the security code and press the OFF key) again.

The interior zones (Interior or Interiors with Delay), have the following characteristics:

Armin

Mode Interior Zones Interior Zones in Zone List 05

STAY

passed Does not appl

NIGHT-STAY

passed Armed

SUMMARY OF ARMING MODES

Features for Each Arming Mode

Arming

Mode

Exit Delay

†

Entry Delay

Perimeter Armed

Interior Armed

STAY

Yes Yes Yes No

NIGHT-STAY

Yes Yes Yes Yes (if in Zone List 05)

INSTANT

Yes No Yes No

AWAY

Yes Yes Yes Yes

MAXIMUM

Yes No Yes Yes

†

The VISTA-15/VISTA-15CN contains an Exit Delay Reset feature that allows the user to exit (fault), close the

door (restore the fault), then re-enter (fault again) the premises within the exit delay time period. Upon re-

entering, a new exit delay time period is begun with the keypad annunciating three rapid beeps. This feature

only resets the exit delay one time for each arming session.

PANIC Keys

There are three PANIC key pairs,

(on keypads 6128 and 6139 keypads if Quick Arm is

disabled in field

✱

21), lettered keys that can be used to manually initiate alarms and send a

report to the Central Station. Lettered keys can only initiate the alarms if Quick Arm (field

✱

21) is disabled.

Each can be individually programmed for 24-hour Silent, Audible, Personal, or Fire

Emergency responses. The Panic function is activated when both keys of the appropriate key

pair are pressed at the same time, or the appropriate lettered key is pressed for at least 2

seconds.

The Panic functions are identified by the system as follows:

Keys Displayed as Zone

1 +

✱

+ #,

3 + #,

Pager Msg is Sent

Notes:

• Keys A, B, and C are not on all keypads

as indicated.

• Key D, if present, with pager enabled in

field

✱

47, sends a 999-9999 message to

the pager. The message signifies

ANY

message the user and recipient have

decided is appropriate, and is

independent of the Quick Arm field.

Important:

For the Silent Panic functions to be of practical value, the system must be

connected to a Central Station.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 131 132

Komentáře k této Příručce

Žádné komentáře

ADEMCO Security System VISTA-15CN Průvodce nastavením Strana 107

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO Security System VISTA-15CN