ADEMCO Security System VISTA-15CN Průvodce nastavením stáhnout pdf (Strana 74)

VISTA-15/VISTA-15CN Installation and Setup Guide

15–12

✱

88 PAGER CHARACTERS

When programmed in field

✱

47, reports are sent to the pager depending upon

the number selected.

| | | | | | | | | | | | | | |

This programming field (

✱

88) allows up to 16 digits to be entered to signal a

pager

. For example, These optional 16 digits may be composed of the

following:

•

PIN number (to identify a specific pager to the paging company)

•

subscriber account number

•

✱

(enter # + 11 to

send

✱

)

•

# (enter # + 12 to

send

)

•

pause (enter # + 13 to allow a 2-second pause)

•

any special character(s) the end user may decide to transmit

All 16 digits do not have to be used.

The preceding 16 digits (if any) are followed by a 7-digit Pager Format,

Pager Format: XXX-YYYY

where:

XXX = a 3-digit event code:

911 = Alarm 101 = Opening (disarm)

811 = Trouble 102 = Closing (arm AWAY)

YYYY = user or zone number (depending on type of event)

The first two digits must always be 00, and must be followed by the 2-digit

user or zone number. Paging is enabled in the Split/Dual Reporting field

✱

by entering a number greater than 5.

NOTE: Some pagers may require an additional delay (pause) to be

programmed into this field in order to receive the entire message. Field

✱

provides an optional pager reporting delay of 0, 1, 2, or 3 minutes for alarm

messages only. Enter

# + 13

for a 2-second pause.

✱

89 EVENT LOG 80% FULL REPORT CODE

0 | 0

If an Event Logging selection is made in field

✱

90, a message can be sent to

the Central Station receiver when the log is 80% full. If the log becomes full, a

new message

overwrites

the oldest message in the log.

NOTE:

Aside from the

selection

made by the installer in field

✱

90, all control

and readout from the log is accomplished via the downloader.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 131 132

Komentáře k této Příručce

Žádné komentáře

ADEMCO Security System VISTA-15CN Průvodce nastavením Strana 74

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu ADEMCO Security System VISTA-15CN