ADEMCO Security System VISTA-15CN Průvodce nastavením stáhnout pdf (Strana 14)

VISTA-15/VISTA-15CN Installation and Setup Guide

2–2

Before installing the cabinet's contents, remove the metal cabinet knockouts required for wiring

entry. Do not attempt to remove the knockouts after the circuit board has been installed.

Mounting the Control's Circuit Board Alone in the Cabinet

To mount the circuit board alone in the cabinet, follow these steps:

1. Hang two short

mounting

clips (provided) on the raised cabinet tabs (see Detail B in

Figure 2).

2. Insert the top of the circuit board into the slots at the top of the cabinet. Make sure that

the board rests on the correct row (see Detail A).

3. Swing the base of the board into the mounting clips and secure the board to the cabinet

with the accompanying screws (see Detail B).

CABINET

CIRCUIT BOARD

CABINET

DETAIL B

SIDE VIEW

OF MOUNTING

CLIPS

DETAIL A

SIDE VIEW

OF BOARD

SUPPORTING

SLOTS

CIRCUIT

BOARD

V15-01-V0

Figure 2. Mounting the PC Board

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 131 132

Žádné komentáře

ADEMCO Security System VISTA-15CN Průvodce nastavením Strana 14